Kohler KD165 - Manual (Page 14)

s example
1. 88 - Optionally this shortly appears
2. ap - Acoustic Piano CD player
3. - First digit of CD player Main controller firmware version, (M) 3 in this example
4. 26 - Second two digits of CD player Main controller firmware, 26 in this example
5. ad - MIDI processor header (AD)
6. 34 - Second two digits of MIDI processor firmware, 34 in this example
7. g1 - Solenoid rail controller firmware version first digit, (G) 1 in this example
8. 42 - Solenoid rail controller firmware version second two digits , 42 in thi
9. 88 - End of Power ON Display sequence, the display test, all segments are enabled
15
THE POWER ON DISPLAY SEQUENCE OF THE DIGITS TRANSLATES TO THE FIRMWARE
VERSION AS FOLLOWING:
TO IDENTIFY CURRENT VERSIONS OF FIRMWARE IN YOUR KOHLER KD PLAYER SYSTEM:
You may be asked by the technical support or piano technician to identify the version of your
Kohler KD Player
firmware.To identify installed firmware please follow these instructions:
- If your KD165 is turned on, turn it OFF first and wait about 30 seconds.
- Turn ON the KD165.
- Observe the Power ON sequence of the digits on the KD165 display.
This sequence will begin to display immediately after turning the Power supply on, it is recommended
to have the pencil and paper handy to note the sequence of the digits.
The version of the firmware as per the example above is:
CD player main controller v 3.26
Midi processor : v34
Solenoid rail controller : v 1.42