Kompernass KH5527 User Manual
Page 6
- 4 -
• ...the 4th red LED, medium heat level, for robust
hair.
• ...the 3rd red LED, lower heat level, for normal
hair.
• ...the 2nd red LED, very low heat level, for fine
hair.
• One red LED blinks, minimal heat level, for very
fine hair.
5.
When the running light progresses to the selected
heat level, double press the On/Off
5
button.
The green LED glows. The buttons are now lok-
ked, the temperature cannot be changed by an
unintentional pressing of the buttons
“+”
4
or “-”
4
.
Note:
When you want to release the temperature
lock, once again double press on the On/Off
5
button. The green LED goes out, the button
lock is released.
6.
Wait until the running light in the LED Indicator
3
glows permanently up to the programmed
temperature. The desired temperature has now
been reached.
Straightening hair
•
Prepare the hair as described in "Before
straightening/ Before curling"..
•
Start with the lower hair sections at the back
of the head. Work over the sides to the front.
1.
Separate a ca. 2 cm wide hair strand.
Attention!
Ensure that the hotplates
2
do not make contact
with the skin of the head. Risk of Burns! Only the tips
1
are cool.
2.
Clamp the hair strands between the hotplates
2
and close to the skin, then press them together.
3.
Pull the whole of the hair strand through the
hotplates
2
, in that you pull the hair straightener
downwards.
4.
Repeat the process with each individual strand.
5.
When you have smoothed all of the strands,
double press the On/Off
5
button to release
the temperature lock. The green LED goes out.
6.
Press the On/Off
5
button until the LED Indica-
tor
3
goes out.
7.
Remove the plug from the wall power socket.
8.
Press the hotplates
2
together and slide the
locking device
7
to the position
.
Curling hair
•
Prepare the hair as described in "Before
straightening/ Before curling".
•
Start with the lower hair sections at the back
of the head. Work over the sides to the front.
1.
Separate a ca. 2 - 3 cm wide hair strand.
Attention!
Ensure that the hotplates
2
do not make contact
with the skin of the head. Risk of Burns! Only the
tips
1
are cool.
2.
Clamp the end of hair strand between the hot-
plates
2
and press them together.
3.
Turn the combi hair styler to wrap the hair
strand around the hotplate.
4.
Dependant on hair type and adjustment,
wait a few seconds.
Attention!
Dependant on the hair type and the heat level, it
can take a differing length of time until a curl is shaped.
Try out various adjustments.
To avoid damaging your hair, ALWAYS start with a
lower heat level and a short waiting time in the hair.
Gradually raise these levels until you discover the
optimal adjustment for you.
IB_KH5527_E40718_LB6 13.10.2008 8:43 Uhr Seite 4