Kathrein UFD 420 - Manual (Page 10)

Receiver operation
10
Bedienung des Receivers
In this chapter, you learn how to select both TV and radio programmes using your
receiver, how to adjust the volume, programme the timer and set up the other func-
tions.
Twin-receiver fundamentals
With its two tuners, the twin receiver allows you to operate the TV set and video re-
corder simultaneously with different programmes.
The twin receiver is equipped with two 4-character LED displays that allow you to
operate the unit with its many options without any difficulty. While the right-hand
LED display shows you the programme slot selected for the TV set (tuner A), the
left-hand display is assigned to the VCR Scart socket (tuner B) for the video re-
corder. However, a prerequisite is that both Sat inputs are connected up to the sat-
ellite receiving system.
Switching the unit on
Switch the unit on via the mains switch on the unit. The last programme slot
selected appears (TV or radio) or else it switches into standby if the unit had been
switched into standby prior to the last switch-off.
In standby mode a horizontal line appears in the LED display “ –“.
•
The key on the remote control switches the unit between normal operation
and standby.
•
You can also turn the unit on using the numeric keys ... and the channel
keys .
Note On switching on via the mains switch, the resulting operating state is always the
same as it was prior to switch-off.
Tuner selection
A switchover between tuner A (right-hand display “TV“) and tuner B (left-hand dis-
play “VCR“) can be made with the
key.
The tuner currently being controlled by the remote control is shown on the OSD
(On Screen Display) by a white field after the programme slot indication. In the LED
display a dot appears after the P or r.
On Screen display LED display
P 3 P 6 P 3 P 6
SAT 1 PRO 7
Switchover between TV and radio mode
Your receiver allows you to receive TV or radio programmes.
After switching on, the receiver takes on either TV or radio mode (depending on the
mode at time of switch-off).
•
Press the key on the remote control to switch between TV and radio mode.
Programme display: TV mode: Radio mode:
P ... R ... or r ...
Note In the radio mode the video signal is turned off blanking out the screen.
In the initial setup menu, a continuous on-screen display of the radio programme
slot can be selected, independent of the TV setting (see section: “Initial settings,
On Screen Displays“).