Kambrook KRH110 - Manual (Page 6)

5
• This radiant heater has hot and arcing or
sparking parts inside. Do not use in areas
where petrol, paints, aerosols, or other
inflammable substances are used or stored.
• Do not operate the radiant heater with the
power cord damaged, frayed or split, wound
around any part of the radiant heater or
in contact with the heated surfaces of the
radiant heater.
• Do not operate any heater with a damaged
cord or plug, or if heater has been dropped
or damaged in any manner. Return heater to
your nearest service centre for examination,
electrical or mechanical adjustment
or repair.
• Do not run the cord under carpeting or cover
the cord with rugs, runner or the like. Arrange
the cord away from traffic areas and where it
will not be tripped over.
• If the supply cord is damaged, it must be
replaced by the manufacturer, its service
agent or similarly qualified persons in order to
avoid a hazard
• Do not insert or allow foreign objects to pass
through the inlet and outlet openings. This
may cause an electric shock, fire or damage
to the radiant heater.
• Do not touch hot surfaces.
• Use this radiant heater only as described in
this instructions manual. Any other use not
recommended by the manufacturer may
cause fire, electric shock or injury and voids
all warranties.
• Do not place the radiant heater near the
edge of a bench or table during operation.
Ensure that the surface is level, clean and
free of water and other substances.
• Keep the radiant heater clean. Follow the
cleaning instructions provided in this book.
• Always ensure the radiant heater is properly
assembled before use. Follow the instructions
provided in this book.
• Do not leave the radiant heater unattended
when in use.
• Do not operate the radiant heater on a sink
drain board.
• Do not allow materials that have been in
contact with oil, petroleum based products
or drying fluids to come in contact with
the heater.
• Do not operate the radiant heater on an
incline plane. Do not move while the radiant
heater is switched on.
• To avoid an electrical overload, it is
recommended that no other appliances are
plugged into the same circuit as your radiant
heater when it is in use.
• The heater is not intended to be installed
adjacent to each other.
• The heater is not intended to be installed
in wardrobes.
• Warning: do not adjust this heater.
• The heater is to be installed so that switches
and other controls cannot be touched by a
person in the bath or shower.
• The heater must not be installed in front of a
socket-outlet.