Konica Minolta Non-Contact 3D Digitizer Range7 - Manual (Page 3)

1
When using this handware, the following points must be strictly observed to ensure correct and safe use. After
you have read this manual, keep it in a safe place where it can be referred to anytime a question arises.
WARNING
(Failure to adhere to the following points may result in death or serious injury.)
Do not use the RANGE7/5 in places where
flammable or combustible gases (gasoline etc.)
are present. Doing so may cause fire. Do not insert or disconnect the AC power cord's
plug with wet hands. Doing so may cause
electric shock.
Always use the AC adapter supplied as a
standard accessory with the RANGE7/5, and
connect it to an AC outlet of rated voltage and
frequency. Failure to do so may in damage the
RANGE7/5, causing a fire or electric shock. Do not disassemble or modify the RANGE7/5 or
AC adapter. Doing so may cause a fire or electric
shock.
Take special care not to allow liquid or metal
objects to enter the RANGE7/5. Doing so may
cause a fire or electric shock. Should liquid or
metal objects enter the RANGE7/5, turn the
power OFF immediately, disconnect the AC
adapter from the AC outlet, and contact the
nearest KONICA MINOLTA-authorized service
facility.
Do not bend, twist or pull the AC power cord
excessively. Also, do not place heavy object on
the AC power cord, or damage or modify the
RANGE7/5. Doing so may cause damage to the
AC power cord, resulting in fire or electric shock.
The RANGE7/5 should not be operated if dirt or
dust has entered through the vent holes. Doing
so may result in a fire. For periodic inspection,
contact the nearest KONICA MINOLTA-
authorized service facility.
When disconnecting the AC adapter's plug,
always hold the plug and pull it to remove it.
Never pull the AC power cord itself. Doing so
may damage the AC power cord, causing a fire
or electric shock.
If the RANGE7/5 will not be used for a long
time, disconnect the AC adapter from the
AC outlet. Accumulated dirt or water on the
prongs of the AC adapter's plug may cause a
fire. If there is any dirt or water on the prongs of
the AC adapter's plug, remove it. Never stare into the laser emitting
window.
Do not place a lens, mirror or optical
element in the passage of the laser
beam. Doing so may converge the
laser beam, resulting in damage to
your eyes, burns or fire. To prevent
the above accidents, make sure that a
wall or similar which can block the
laser beam is located behind the
object.
The RANGE7/5 should not be operated if it is
damaged, or smoke or odd smells are detected.
Doing so may result in a fire. In such situations,
turn the power OFF immediately, disconnect the
AC adapter from the AC outlet, and contact the
nearest KONICA MINOLTA-authorized service
facility.
Safety Precautions
CAUTION
Be sure to connect the AC power cord plug to an
AC outlet that has a grounding terminal.
Do not place the instrument on an unstable or
sloping surface. Doing so may result in its
dropping or overturning, causing injury. Take
care not to drop the instrument when carrying it.
Make sure that the AC outlet is located near the
RANGE7/5 and that the AC adapter's plug can
be easily connected and disconnected.
(Failure to adhere to following points may result in injury or damage to this
instrument or other property.)