KORG ER-1mkII - Manual (Page 31)

31
4.Pattern mode
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
4.P
atter
n mode
Pattern Set
Pattern Set is a function that lets you assign your favorite pat-
terns to each of the sixteen step keys, and switch them at the
touch of a key.
During playback, you can successively switch patterns to per-
form a song.
By using the SELECT key in conjunction with this to switch
pattern set groups, you can register and select 16 x 4 (total of
64) patterns.
Using Pattern Set to perform
(Pattern Set Play)
Press the Play/Pause key to begin playback.
Hold down the PATTERN SET key and press a step key to
switch to the pattern that was registered for that step key.
By holding down the PATTERN SET key and pressing a SE-
LECT
key, you can switch to a different group of registered pat-
tern sets. The pattern set group will be indicated by the lower
line of the Select LEDs (red).
By holding down the SHIFT key and pressing the PATTERN
SET
key, you can hold the Pattern Set function (the key will
light).
To defeat the Hold condition, press the PATTERN SET key once
again (the key will go dark).
1 2 3 4 5 14 15 16
Example
Step key
Select LED
1
2
3
4
A01 A20 B03 B04 A51 A20 B43 B61
C21 C23 C56 C64 C28 C21 A07 A08
B01 B02 B04 B62 A01 A05 A45 A64
D01 D02 D03 D04 D05 D07 D08 D09
Pattern set 1 Pattern set 3
Hold down the SHIFT key and
press the PATTERN SET key to
hold the function
In Pattern Set Play, the timing at which patterns will change,
tempo adjustment, and functions such as Reset & Play etc. are
the same as for Pattern Play.
Pattern Set cannot be used during recording. When you
enter recording (ready) mode, Pattern Set will be cancelled.
Registering a pattern for Pattern
Set
1. With playback stopped, continue pressing the PATTERN SET
key (or Hold it) and press the step key for the location that
you wish to register.
2. While continuing to press the PATTERN SET key (or while
Hold is still in effect), rotate the dial to select the pattern num-
ber that you wish to register. Release the PATTERN SET key
(or defeat Hold) to complete the registration process.
3. To save the pattern set registrations, press the Stop/Cancel
key to stop playback. Continue pressing the PATTERN SET
key, and press the WRITE key (the WRITE key will blink).
4. The display will blink "PSt." Press the WRITE key once again
to save the data.
To cancel, press the Stop/Cancel key.
If the Global mode Memory Protect setting is on, it will not
be possible to write the data. In this case, turn off the Glo-
bal mode Memory Protect setting before you execute the
Write operation.
Never turn the power off during the Write operation. This
may damage the data.
2
1,2
1
3,4