Kenwood KTC-1000R - Manual (Page 8)

Please do not install the unit near the
dashboard, the rear tray, or other important
components. Doing so could lead to injury or
accident should the unit come off due to a shock
and strike a person or an important component.
Tapping screws should be used for mounting.
(Attachment with velcro strips, although easy,
can come off with a shock.)
2CAUTION
Installation
8
English
Installation for Hideaway unit ■
Attach the installation brackets to the sides
of the hideaway unit using the sems bolts
(M4
×
8 mm).
Use the tapping screw (ш4
Ч
16 mm) to
secure the hideaway unit to the audio
board.
2 1
● Securing to audio board
,,,,,,
,,,,,,
● Securing to pile carpet
Peel the protective strips off of the velcro
strips, attach them to the bottom of the
hideaway unit, and secure to the pile carpet.
,,,,,,,
,,,,,,,
,,,,,,,
Sems bolts
(M4
×
8 mm)
(Accessory2)
Tapping screw
(ш4
Ч
16 mm)
(Accessory3)
Installation brackets
(Accessory1)
Velcro strips
(Accessory4)
PROBLEM
The power does not turn on.
No sound can be heard, or
the volume is low.
Nothing happens when the
buttons are pressed.
POSSIBLE CAUSE
The fuse has blown.
• The Attenuator function is turned
on.
• The fader and/or balance settings
are set all the way to one side.
• The input/output cables or wiring
harness are connected incorrectly.
The computer chip in the unit is not
functioning normally.
SOLUTION
After checking for short circuits in the
cables, replace the fuse with one
having the same rating.
• Turn off the Attenuator function.
• Reset the fader and/or balance
settings.
• Reconnect the input/output cables
and/or the wiring harness correctly.
See the section on "Connecting
Cables to Terminals".
Press the reset button on the unit
Troubleshooting Guide
What might appear to be a malfunction in your unit may just be the result of
slight misoperation or miswiring. Before calling service, first check the following
table for possible problems.