Kodak Z1485 IS - Manual (Page 55)

Troubleshooting
www.kodak.com/go/support 49
In Review mode, a
blue or black
screen is displayed
instead of a
picture. ■ Transfer the picture to the computer ( page 44 ), then format the card or
internal memory ( see page 33 ).
Caution: Formatting a card deletes all pictures and videos,
including protected files.
Shutter button
does not work. ■ Turn on the camera ( page 2 ).
■ Wait until the Ready light stops blinking red before attempting to take
another picture.
■ Transfer pictures to the computer ( page 44 ), delete pictures from the
camera ( page 15 ), switch image storage locations ( page 30 ), or insert
a card with available memory ( page 3 ).
Slide show does
not run on external
video device. ■ Adjust the camera Video Out setting (NTSC or PAL, see page 32 ).
■ See the external device’s user’s guide.
Picture is too light. ■ Move so there is at least 2 ft (0.6 m) between the camera and the
subject.
■ Decrease Exposure Compensation ( page 38 ).
Picture is not clear. ■ Clean the lens ( page 61 ).
■ Make sure your camera is not in Close-up mode.
■ Move so there is at least 2 ft (0.6 m) between the camera and the
subject.
■ Press the shutter button halfway to focus and set exposure. When the
ready light turns green, press the Shutter button completely down.
■ Place the camera on a flat, steady surface or use a tripod.
Picture is too dark. ■ Turn on the flash ( page 9 ).
■ Move so there is no more than 11.8 ft (3.6 m) in wide angle and
6.9 ft (2.1 m) in telephoto between the camera and the subject.
■ Use Fill flash ( page 9 ) or change your position so light is not behind
the subject.
■ Increase Exposure Compensation ( page 38 ).
If Try one or more of the following