KITCHENAID 2307890A - Manual (Page 6)

6
Front View
■ Width dimensions were measured from trim edge to trim
edge.
■ Height dimensions are shown with leveling legs extended ¹⁄₈"
(3 mm) below the rollers.
*When leveling legs are fully extended to 1 ¹⁄₄" (32 mm) below
rollers, add 1
¹⁄₈" (29 mm) to the height dimensions.
Tipping Radius
Be sure there is adequate ceiling height to stand the refrigerator
upright when it is moved into place.
■ The dolly wheel height must be added to the tipping radius
when a dolly is used.
■ If needed, the tipping radius can be reduced. See “Reduce
Tipping Radius.”
Side Tipping Radius
NOTE: Tip on side only.
Door Swing Dimensions
The location must permit the door to open to a minimum of 90°.
Allow 4
¹⁄₂" (11.4 cm) minimum space between the side of the
refrigerator and a corner wall.
NOTE: More clearance may be required if you are using overlay
panels or custom handles.
To adjust the door swing, see “Adjust and Remove Door.”
36" (91 cm) Models
36
¹⁄₄
" (92 cm)
*83
¹⁄₈
"
(211 cm)
A. Tip this side only
90
¹⁄₂
"
(229.9 cm)
A
110˚
90˚
23"
(58 cm)
51"
(130 cm)
59"
(150 cm)
130˚