Kambrook STEAMLINE KI730 - Manual (Page 8)

8
Operating Instructions
continued
Stand the iron on its heel and turn the
Temperature Control to MIN.
Plug the power cord into a 230V or 240V
power outlet and switch on.
Select the temperature setting required
by rotating the
Temperature Control dial so that the
desired setting is aligned with the
Temperature Indicator.
The Heating Indicator light will illuminate
while the iron heats to the selected
temperature.
Once the light has switched off, the iron
has reached the set temperature and
is ready for use. The light will cycle on
and off during use as the iron maintains
the temperature selected on the
Temperature Control.
CAuTION: The iron
incorporates a thermal
safety fuse to protect the
iron from over-heating.
However the iron should
not be left unattended
while it is connected to
the power outlet. Special
care should always be
taken when there are
children in the home/
vicinity of the iron.
CAuTION: Never leave
the iron unattended while
it is connected to an
electrical outlet. Special
care should always be
taken when there are
children in the vicinity.
Steam Ironing
When filling the iron with water, ensure
that the iron is unplugged. Set the Steam
Control to the DRY position and holding
the iron at an angle use the water cup
supplied to fill the water tank. Never
exceed the maximum water level as
indicated (MAX) on the side of the water
tank.
Tap water can be used in your Kambrook
Steamline iron unless it is particularly hard,
in which case it is recommended that
distilled or demineralised water be used.
To Operate the
Steam Control
As per the indications on the
Temperature Control and in Table A (See
section ‘Setting the Temperature’) steam
ironing is only possible at higher ironing
temperatures, indicated with Cotton/
Linen on the Temperature Control.
Plug the power into a 230V or 240V power
outlet and switch the power on.
Set the Temperature Control to the
required position within the steam range
and wait until the Heating Indicator Light
has gone out.
Set the Steam Control (on top of the
handle) to the required setting.
Your Kambrook iron is now ready for use.
KI730_KI760_KI780_IB_D12.indd 8 5/12/12 11:53 AM