Karcher BR VS 400 - Manual (Page 8)

English BR VS 400 *USA 8
EACH TIME BEFORE OPERATION
– Check the cleaner and especially
the power cable for damage
– Checked the rotary brushes for the
presence of foreign objects
– Fit the rotary brush that is suitable
for the job
– If necessary top up the cleaning
agent solution in the tank
– Connect the plug to the power
cable
– Hang the strain-reliever
– Plug the cable into the power
socket
– Check that there are no obstacles
in the area to be cleaned
* See the Operation Chapter for the
description
OPERATION
WARNING!
The cleaner must always be in motion
during operation!
Do not work on one spot as this may
damage the floor covering!
Do not start an unfilled appliance on
delicate floors!
Prior to start-up, tilt unit, activate
cleaning agent supply and switch on
drive unit for brush rollers.
Working in a lateral direction
Pull the catch upwards and hold
Tip the pushing handle backwards
Pull the lower lever;
* Rotary brush drive ON
– Move the cleaner to the LEFT and
RIGHT by turning the pushing
handle
– At the same time go backwards
slowly
– Press the top switch-stirrup as
required, the cleaning agent
solution is fed to the rotary brooms
Working in lanes
Press the pushing handle downwards
and turn to the LEFT or RIGHT
Pull the catch upwards and hold
Tip the pushing handle backwards
Pull the lower lever;
* Rotary brush drive ON
– Move the appliance slowly
backwards or forwards in long
sweeping movements
– Press the top switch-stirrup as
required, the cleaning agent
solution is fed to the rotary brooms
Switching off the cleaner
Release both levers
– Tip the pushing handle forwards;
* The catch locks automatically
– When necessary push the pushing
handles down and turn back to the
initial position
Note:
Do not leave the cleaner on the rotary
brushes