Kambrook SNUGASABUG KRH100 - Manual (Page 9)

8
Before First Use
Remove your heater from its carton
and associated protective wrapping.
Unwind the cord to its full length and
remove any protective cardboard or
foam that may have been used to
minimise transportation damage.
Place the heater on a firm, level
surface in a stable upright position.
Visually inspect the air inlet and
outlets to ensure no foreign material is
blocking these areas.
Turning Your Heater On
Plug the cord into a 230V or 240V
electrical outlet. Be sure the plug
fits tightly as a loose fit will cause
overheating and damage the plug.
NOTE: To avoid an electrical
circuit overload, it is
recommended that no other
appliances are plugged into the
same circuit with your heater
when you switch the unit on.
• The heater has 2 quartz elements
which are controlled by two
switches located at the back of
the heater.
• To turn the heater ON, select the
desired switch setting.
• Switching ON only the ‘BOTTOM
ELEMENT’ or ‘TOP ELEMENT’,
the heater will be in MEDIUM
heat mode.
• Switching ON both the ‘BOTTOM
ELEMENT and ‘TOP ELEMENT’, the
heater will be in HIGH heat mode.
• To turn the heater OFF, switch all
switches to the ‘OFF’ position.
Using Your Kambrook Heater
ThermoGuard Overheating
Safety Device
Your heater is fitted with a safety
device that switches off the heater
in the event of overheating. Should
this heater stop working, turn off the
heater and return the heater to your
nearest service centre for examination
or repair.