Kodak i50 - Manual (Page 15)

10 A-61182 October 2001
Requirements and software installation
To operate the scanner at its optimum speed, the following minimum configuration is
required.
NOTE: The actual performance of the system depends on the scanning application,
choice of scanning parameters, and the PC configuration. If the scanner is not
performing at the optimal speed, using a faster PC and/or more RAM may be
necessary to obtain the rated throughput.
•
IBM PC (or compatible) with a Pentium 933 MHz processor
•
Microsoft Windows 95, Windows 98, Windows NT 4.0, Windows 2000, or
Windows Millennium Edition (Me)
•
100 MB of available hard disk space (200 MB is recommended)
•
128 MB of RAM
•
Monitor (VGA)
•
Mouse
•
CD-ROM drive
Installing the
scanner drivers 1. Start your PC and Windows application.
2. Insert the KODAK i50/i60 Scanner CD that contains the device drivers in your
CD-ROM drive.
NOTE: If the CD does not start automatically, click on the Start button and choose
Run, then type d:\driver\setup.exe (where “d” is the letter of your CD-ROM
drive). Click on the OK button.
3. Follow the instructions on the screen to complete the driver installation.