Kenwood KAC-PS401M - Manual (Page 13)

English
13
Specifications
Specifications subject to change without notice.
Audio Section
Max Power Output (2
Ω
) ....................................................................................................1200 W
×
1
Rated Power Output (+B = 12.0 V)
(4
Ω
) ..................................................................................200 W
×
1 (20 Hz ~ 20 kHz, 0.05 % THD)
(2
Ω
) ....................................................................................................400 W
×
1 (1 kHz, 0.5 % THD)
Rated Power Output (+B = 14.4 V)
(4
Ω
) ........................................................................................300 W
×
1 (DIN : 45324 , +B = 14.4V)
(2
Ω
) ....................................................................................................600 W
×
1 (1 kHz, 0.5 % THD)
Frequency Response (+ 0 , – 3 dB) ................................................................................5 Hz ~ 50 kHz
Total Harmonic Distortion (Rated power)
# ....................................................................0.002 % (1 kHz)
Sensitivity (rated output) (MAX.) ..................................................................................................0.2 V
Sensitivity (rated output) (MIN.) ....................................................................................................5.0 V
Signal to Noise Ratio ..................................................................................................................105 dB
Input Impedance ..........................................................................................................................10 k
Ω
Damping Factor ....................................................................................More than 9900 (at
∑
connect)
Low Pass Filter Frequency (24 dB/oct.) ..............................................................50 ~ 200 Hz (variable)
Infrasonic Filter Frequency (24 dB/oct.) ..................................................................15 / 20 / 25 / 30 Hz
Band Reject Filter Frequency ..............................................................................40 ~ 200 Hz (variable)
# Sensitivity = Mini. , Through LPF (30 kHz)
General
Operating Voltage ....................................................................................12.0 V (11 ~ 16 V allowable)
Current Consumption (4
Ω
, +B = 12.0 V, 10 % THD) ....................................................................36 A
Dimensions (W
×
H
×
D) ........................................................................................272
Ч
64
Ч
380 mm
Weight..........................................................................................................................................7.0 kg
Troubleshooting Guide
PROBLEM POSSIBLE CAUSE SOLUTION
If the slide panel moves of
its own accord.
The external amplifier
controller (B.M.S.) will not
work.
• The system is in DEMO mode.
• The slide panel has gone into
remote operation mode.
• The B.M.S. switch is set to
"B.M.S. (+6)".
• The external amplifier control
cable has come loose.
• Cancel DEMO mode by pressing
the OPEN/CLOSE button.
• Check the B.M.S. and operate
the slide panel remotely or
manually.
• The B.M.S. switch is set to
"(REMOTE)".
• Check that the external amplifier
control cable is properly
connected.