Kenwood eXcelon KAC-X10D - Manual (Page 6)

6 English
Controls
1 Fuse (40 A × 1)
NOTE
If you can’t find the specified capacity fuse at your store etc., consult your
Kenwood dealer.
2 Battery terminal
3 Ground terminal
4 Power control terminal
Controls the unit ON/OFF.
NOTE
Controls the unit power. Be sure to connect it with all the systems.
5 Speaker output terminals
As this unit accepts speakers with a minimum impedance of 1 ohm, connect
speakers with 1-ohm or higher impedance to these terminals.
2CAUTION
The rated input of the speakers should be no less than the maximum output
of the amplifier. Otherwise malfunction may result.
6 ISF (infrasonic filter) switch
Ultralow frequencies that cannot be reproduced even by a subwoofer
speaker do not become sound but become unnecessary oscillations, which
affect the sound by causing distortion, etc. Setting this switch to "15 Hz" or
"25 Hz" cuts the frequencies below the respective frequency.
This improves the reproduction performance of the speakers by eliminating
unnecessary oscillations which will not become sound.
7 LPF(Low-Pass Filter) FREQUENCY control
This control adjusts the frequency band output from this unit.
8 LINE OUT FILTER switch
Changing over the audio signal output to the LINE OUT terminal.
ON position:
The audio signal adjusted when setting LPF, INPUT SENSIVITY control and
Bass boost (optional accessory) is output to the LINE OUT terminal.
OFF position:
The audio signal input from the LINE IN terminal is output to the LINE OUT
terminal (through output).
2CAUTION
The volume of the audio output to the LINE OUT terminal is different in ON
and OFF position. Remember this when changing the LINE OUT FILTER switch
from ON to OFF.
9 INPUT SENSITIVITY control
Set this control according to the pre-output level of the center unit
connected with this unit.
NOTE
For the pre-output level, refer to the <Specifications> in the instruction
manual of the center unit.
0 REMOTE terminal
Connects the Remote cable.
NOTE
Use the Remote cable of the accessory.
! LINE IN terminal
@ LINE OUT terminal
The audio signal set with the LINE OUT FILTER switch will be output.
# Power idndicator
When the power is turned on, the Power indicator lights.
If the Power indicator does not light when the power is turned on, the
protection function may be activated. Check whether there is any indication
of trouble. (See page 2)
$ BOOST LEVEL (Bass boost level) control
Sets the level by which the low frequency range should be boosted.
% Power idndicator
^ FREQUENCY (Bass boost frequency) control
Sets the center frequency around which the low frequency range should be
boosted.
40
} 
p q r s t u v w x y z {
|
~
Remote controller
(Optional accessory)