Kenwood XD-A75 XD-A55 - Manual (Page 14)

14 EN
To interrupt playback :
1 Press the 8 button on the remote control.
• “ 8” will light up.
2 Press the 3 button to resume playback from the
same point.
To stop playback :
Press the 7 STOP button.
To remove the CDs :
Whilst in the stop mode, press the 0 OPEN/CLOSE
button.
• The disc tray will open. Remove the two discs.
Then, press the DISC SKIP button to rotate the
disc tray and remove the remaining disc.
After use :
Press the POWER / ON/STANDBY button to enter
the standby mode.
Cautions :
•
Do not carry the unit with discs left in the disc
trays. The disc may become loose inside the
unit and they may be damaged or cause dam-
age to the unit. This may also cause malfunc-
tions.
• Do not place two CDs in one disc position.
• Do not push the disc tray whilst it is moving.
• Do not attempt to turn the disc tray by hand.
This may cause malfunctions.
• If the power fails whilst the tray is open, wait
until the power is restored.
• If the disc tray is stopped forcibly, “ERR” will
appear in the display and the unit will not func-
tion.
If this occurs, press the POWER / ON/STANBY
button to enter the standby mode and then turn
the power on again.
• If TV or radio interference occurs during CD
operation, move the unit away from the TV or
radio.
• If a disc is damaged, dirt, or loaded upside
down, the disc will be skipped and the next
disc will automatically play.
Disc number selection
1
When stopped, press the DISC SKIP button.
2
Press the 3 button.
• The next disc playback will begin, after which
each following disc will be played sequentially.
Notes :
• When the DISC SKIP button is pressed during
playback, playback will begin automatically from
the next disc. (It is not necessary to press the
3
button.)
• When one of the disc number buttons (DISC 1-
DISC 3) is pressed during playback, playback of
the selected disc will begin automatically. (It is
not necessary to press the
3 button.)
2
DISC 1 - DISC 3
1
1
2