Kompernass KH 4300 - Manual (Page 8)

- 6 -
Bobbin caps
If using non-industrial thread bobbins, remove the
bobbin supports and place the bobbin caps on the
thread bobbins.
Connecting the foot pedal
Insert the plug of the footpedal g into the connection
for the footpedal 5 and the power plug j into a
mains power socket.
To switch the machine on, press the power switch 7.
Attention!
During absences from the machine or when doing
maintenance work, always remove the plug j from
the mains power socket. Injury hazard!
Controlling the sewing speed
The sewing speed is controlled by means of the
footpedal h. The sewing speed is changed by ap-
plying more or less pressure to the footpedal h.
Safety switch
This machine is fitted with a micro safety switch. You
cannot start the machine if the front flap 8 is open.
Close the front flap 8 before you start to sew.
Fitting the waste container
The waste container k collects remnants during
sewing, so that your workplace stays tidy. Place the
waste container k between the machine and the
table.
Handwheel
Note:
Always turn the handwheel 6 towards yourself,
that is, in the same direction as with a domestic
sewing machine.
Front flap
To open the front flap 8, slide it as far as possible
to the right and, at the same time, draw it towards
yourself.
IB_KH4300_33077_LB6.qxd 02.06.2009 13:40 Uhr Seite 6