Kraus USA Kralin Wireless Access Point 54MB Single Port Cod. KR.XJ - Manual (Page 5)

www.kraun.it 5
User’s Manual
If the result displayed is similar to that shown in figure 4-1, the connec-
tion between your PC and the AP has been established.
Figure 4-2: Failed result of Ping command
If the result displayed is similar to that shown in figure 4-2, it means that
your PC has not connected to the AP. Please check it following these
steps:
1. Is the connection between your PC and the AP correct?
Note: The LED of LAN port on the AP and LED on your PC’s adapter
should be lit.
2. Is the TCP/IP configuration for your PC correct?
Note: If the AP’s IP address is 192.168.1.1, your PC’s IP address must
be within the range of 192.168.1.2 ~ 192.168.1.254, the gateway
must be 192.168.1.1 .
5. Configuring the AP
This chapter describes each Web page’s key functions.
5.1 login
With a Web-based (Internet Explorer or Firefox) utility, the Wireless Ac-
cess Point 54MB Single Port is easy to configure and manage. The Web-
based utility can be used on any Windows, Macintosh or UNIX OS with
a Web browser.
Connect to the AP by typing http://192.168.1.1 in the address field of
Web browser.
Figure 5-1: Login to the AP
After a moment, a login window will appear similar to that shown in
Figure 5-2. Enter admin for the User Name and Password, both in lower
case letters. Then click the OK button or press the Enter key.
Figure 5-2: Login Windows
Note: If the above screen does not prompt, it means that your
Web browser has been set to a proxy. Go to Tools menu>Internet
Options>Connections>LAN Settings, in the screen that appears, cancel
the Using Proxy checkbox, and click OK to finish it.
After your successful login, you can configure and manage the AP. There
are six main menus on the left of the Web-based utility. Submenus will
be available after you click one of the main menus. The six main menus
are: Status, Network, Wireless, DHCP, Wireless Advanced Settings and
System Tools. On the right of the Web-based utility, there are the detailed
explanations and instructions for the corresponding page. To apply any
settings you have altered on the page, please click the Save button.
There are the detailed explanations for each Web page’s key functions
below.
5.2 Status
The Status page displays the AP’s current status and configuration. All
information is read-only.
1. Network
This field displays the current settings or information of the Network,
including the MAC address, IP address and Subnet Mask.
2. Wireless
This field displays basic information or status of the wireless func-
tion, including Operating Mode, SSID, Channel, Mode, MAC Address
and IP Address.
3. Traffic Statistics
This field displays the AP’s traffic statistics.
4. System Up Time
The time of the AP running from it’s powered on or reset.
Figure 5-3: AP Status
5.3 Network
You can configure the IP parameters of Network on this page.
Figure 5-4: Network