Konica Minolta Di1610 - Manual (Page 128)

6.9 What Does Each Message Mean? 6
Di1610/Di1610p 6-25
W
he
n
a Mes
s
age Ap
pear
s
Ch
apt
er
6
6.9 What Does Each Message Mean?
Message Cause Action
*REMOVE PAPER IN BYPASS
TRAY* Paper is loaded in the Bypass
Tray. Remove the paper from the
Bypass Tray.
FRONT COVER OPEN
CLOSE FRONT COVER
The Front Cover of the main
unit is open or not securely
closed. Securely close the Front Cover.
DOCUMENT COVER OPEN
CLOSE DOCUMENT COVER
The Auto Document Feeder is
lifted up (while a document is
loaded into it). Securely close the Auto
Document Feeder or remove
the document from the Auto
Document Feeder.
DOC.FEED COVER OPEN
CLOSE DOC.FEED COVER
The Document Feeder Cover is
open. Securely close the Document
Feeder Cover.
MEMORY FULL
PRESS ANY KEY
The size of the data for the
scanned document has
exceeded the capacity of the
memory. Press the [Panel Reset] key, or
turn the machine off, then on
again. (The scanned data
should be cleared from the
memory.)
MACHINE TROUBLE
SERVICE CALL (C####)
Some problem occurred in the
machine. Turn the machine off, then on
again. If the error is still
displayed, contact your service
representative.
FUSER COVER OPEN
CLOSE FUSER COVER
The Fuser Cover of the main
unit is open or not securely
closed. Securely close the Fuser
Cover.
PAPER JAM
OPEN FRONT COVER
A paper misfeed occurred. Perform the misfeed-clearing
procedure. (p. 6-16)
All misfed paper was not
removed from the main unit.
The Fuser Cover of the main
unit is open or not securely
closed. Close the Fuser Cover, then
open and close the Front
Cover.
INCORRECT T/C TYPE
CHANGE T/C
Incorrect type of toner cartridge
is installed. Install the correct type of toner
cartridge. (p. 6-5)
Toner cartridge is not installed. Install the toner cartridge.
(p. 6-6)
TEXT
Ч
1.00 1
д[A]ü #XXX: EMPTY
(While specifying copy settings)
The selected paper tray has run
out of paper.
“#” indicates the paper tray, and
“XXX” indicates the paper size. Either load paper of the
specified size into the specified
paper tray, or press the [Paper]
key and select a different paper
size.