Kidde 9 Volt Battery Operated Photoelectric/Ionization Smoke Alarm PI9000 - Manual (Page 7)

dren and others from removing the alarm from trim ring. NOTE: To
remove the alarm when the tamper resist tab is engaged, press
down on the tamper resist tab, and rotate the alarm off of the
trim ring (see figure 6).
After installation, test your alarm by depressing and holding down
the test button for at least 5 seconds. This should sound the alarm.
4. OPERATION AND TESTING
OPERATION: The smoke alarm is operating once a fresh battery is
installed and testing is complete. When products of combustion
are sensed, the unit sounds a loud 85db pulsating alarm until the
air is cleared.
HUSH CONTROL: The “HUSH” feature has the capability of tem-
porarily desensitizing the alarm circuit for approximately 8 minutes.
This feature is to be used only when a known alarm condition,
such as smoke from cooking activates the alarm. The smoke alarm
is desensitized by pushing the “HUSH” button on the smoke alarm
cover. If the smoke is not too dense, the alarm will silence immedi-
ately and the red LED will flash every 2 seconds for approximately
8 minutes. This indicates that the alarm is in a temporarily desensi-
tized condition. The smoke alarm will automatically reset after
approximately 8 minutes, and sound the alarm if smoke is still
present. The “HUSH” feature can be used repeatedly until the air
has been cleared of the condition causing the alarm. Pushing the
test/reset button on the alarm will end the hush period.
FIGURE 6
A A
Posts