Kyocera IRIDIUM KI-G100 - Manual (Page 25)

Kyocera KI-G100 GSM Handset - Ver.
0.3 Preliminary Version - 01.1999
6 SECURITY
Here you can lock the keypad, enable or disable the SIM Card’s PIN check,
change its PIN code, change its PIN2 code, enable or disable the Fixed Dialling
Memory (FDN) function.
61 Key Lock
The keypad can be locked in standby mode to avoid any undesired function (e.g.
accidental dialling). In that case, only the key
can be used to switch off the
phone.
• To unlock the keypad in standby mode, press and hold the left Softkey .
During an incoming call, you will be prompted to
unlock the keypad to answer the call:
• Press (
OK ) and then to answer the call
Keylock Off?
OK
62 PIN
If this function is activated, your SIM Card is protected against unauthorised use
with a Personal Identification Number (PIN) of your choice, that will be requested
each time the phone is switched on.
63 New PIN
You can change here the PIN code of your SIM Card. It must contain a minimum
of 4 and a maximum of 8 digits.
Caution: if you enter the PIN code incorrectly 3 times, your SIM Card
will be blocked and you must enter the PUK code to unblock it (see
section “6. Problem Solving / Helpful Hints”).
64 New PIN2
The PIN2 code of your SIM Card allows you to access some special functions of
the SIM Card such as the setting of charge parameters (see Menu “3 Costs”) or
the Fixed Dialling Numbers function (see Menu “65 FDN”).
Menus 21