Kompernass XQ 310 - Manual (Page 5)

7 GB/IE
Technical Data
Nominal voltage: 230 V ~ 50 Hz
Nominal power: 310 W
Idle speed: n
0
6,000 - 11,000 rpm
Idle oscillation speed: max. approx. 22,000 rpm
Oscillation circle:
2.1 mm
Sanding paper size max.: approx. 280 x 115 mm
Protection class:
II /
Information on sound levels and vibration:
A-weighted noise level.
Sound pressure level: 71 dB(A)
Sound power level:
85 dB(A)
Weighted acceleration, typical:
Hand-arm vibration:
2.149 m / s 2
Safety Instructions
J Important! When using electrical tools, the
following basic safety measures must be followed
to protect against electric shock, injuries and fire
hazards. Read and take note of these operating
instructions and the safety advice contained
therein before using the appliance, and keep
them for future reference. Not following the
instructions listed below can result in electric
shock, fire and / or serious injuries.
Safety at the Workplace
J Keep working area clean and tidy. Ensure
good illumination of the working area. Cluttered
and poorly lit working areas can lead to accidents.
J Explosion hazard! Do not work
with the appliance in areas subject to
the risk of explosions or in areas
where flammable liquids, gases or dusts are
located. Electrical hand tools produce sparks
which could ignite the dust or vapours.
J Keep children and other unauthorised
personnel at a safe distance when
using electrical hand tools.
Should you become distracted, you could lose
control over the appliance.
Electrical Safety
Avoid life-threatening
electric shocks:
J The power plug of the appliance must match the
power socket. Never manipulate the electrical plug.
Do not use adapter plugs together with earthing-
protected appliances. Unmodified plugs and suit-
able wall sockets reduce the risk of electric shock.
J Avoid physical contact with earthed surfaces,
such as pipes, heaters, stoves and refrigerators.
There is an increased risk of electrical shock if
your body is earthed.
J Protect the appliance from rain and
moisture. If water or moisture enters
into an electrical appliance, the risk
of electrical shock increases.
J Do not use the power cord for purposes other
than intended, e.g. do not use the cord to carry
the appliance, for hanging it up or for pulling
the plug from the wall socket. Keep the cable
away from heat, oil, sharp edges or moving
appliance parts. Damaged or tangled cords or
plugs increase the risk of an electric shock.
J A damaged appliance, power cord
or power plug mean a risk of life-
threatening electric shock.
Check the condition of the appliance, the power
cables and the power plugs on a regular basis.
J Check the power cord of the electric tool on
a regular basis and have it replaced by a
recognised specialist if damaged.
Introduction / Safety Instructions