Kompernass KH 701 - Manual (Page 7)

- 5 -
Risk of injury from rotating parts!
NEVER reach into the mixing bowl when it is in use.
Only change accessories when the drive motor j
is at standstill! After being switched off, the drive motor
j
continues to run for a short time. The appliance
may only be used when the drive openings not
being utilised are covered with drive protection lids.
In cases of malfunction switch the appliance off and
remove the plug from the wall socket, this will avoid
an unintentional switching-on of the appliance.
Refilling with ingredients
• Turn the appliance off with the rotary switch g.
• Turn the rotary switch g to P and hold it firmly
until the drive motor j comes to a standstill (Fig. 2).
• Remove the lid.
• Press the unlocking button f and bring the swivel
arm h into operating position 5 (see chapter
„Operating positions“).
• Refill with ingredients or insert the ingredients
through the refill opening in the lid.
On task completion
• Turn the appliance off with the rotary switch g.
• Turn the rotary switch g to P and hold it firmly
until the drive motor j comes to a standstill (Fig. 2).
• Remove the lid.
• Press the unlocking button f and bring the swivel
arm h into operating position 4 (see chapter
„Operating positions“).
• Remove the accessories from the drive motor j.
• Remove the mixing bowl y.
• Clean all parts (see chapter „Cleaning and
care“).
Working with the food
processor
Note: Ensure that on the swivel arm h neither the
kneading hooks q, the whisk e nor the mixing
beater w are attached.
Proceed as follows to prepare the appliance for
operation with the food processor u:
• Press the unlocking button f and bring the swivel
arm h into operating position 4 (see chapter
„Operating positions“) (Fig. 1).
• Insert the mixing bowl y. The base of the mixing
bowl y must engage in the recesses k on the
appliance.
• Press the unlocking button f and bring the swivel
arm h into operating position 1 (see chapter
„Operating positions“).
• Remove the drive protection lid for the food
processor u (Fig. 4).
• Insert the food processor u with the drive shaft
a into the drive opening (The marking on the
food processor u to the marking on the swivel
arm h) and turn it clockwise as far as it will go.
• Remove the lid with stodger d.
• Depending on the task to be performed, place
the cutting s, rasping o or rubbing i disc onto
the drive shaft a of the food processor.
• Place the lid with stodger d on the food processor
u and latch it down.
• Set the rotary switch g to the desired level.
Note: Do not press too many ingredients in the
food processor u. Take note of the table in the
chapter „Recommended filling quantities“.
• Insert ingredients through the loading shaft with
the stodger d.
IB_KH701_35701_LB6 30.06.2009 14:44 Uhr Seite 5