Kenwood HM-353V - Manual (Page 55)

55
Knowledge sections
Important Items
PGM FULL
÷ An attempt is made to select a 33rd track during programming of CD.
PGM Mode
÷ An attempt is made to start random playback in the program mode. Exit from the
program mode before random playback.
ª
RANDOM Mode
÷ An attempt is made to perform TAPE O.T.E. recording while the unit is in the CD
random play mode. Exit from the random play mode.
⁄
NO Disc
÷ No disc is loaded.
÷ The loaded CD-R disc has not been finalized.
ERROR
÷ The disc is abnormal (causing a trouble such as impossibility of reading). Replace it
with a normal disc.
NOT AUDIO ÷ The disc or the signal recoded in it is incompatible with this unit. This is not mal-
function of this unit.
no FILE
÷ The disc does not contain MP3 files. Replace it with a disc containing files that can
be played back with this unit.
unknown
÷ The disc is of the type that cannot be played back with this unit.
Displayed messages and actions to be taken against them
Meaning Displayed Message
Cassette deck section
÷ Clean the head referring to "Maintenance". Q
÷ The tape is wound too tight due to irregular winding.
÷ Play a recorded tape.
÷ Press operation keys in more than a few seconds after closing
the cassette holder. ¡
÷ Change the tape transport direction or reverse the tape insertion
orientation. ¡
÷ Press in stop mode.
÷ Reset the microcomputer. E
÷ Clean the head referring to "Maintenance". Q
÷ Try another tape.
÷ The recording level is not set properly (when the AUX input is
recorded).
Adjust the AUX input level.
e
÷ Demagnetize the head referring to "Maintenance". Q
÷ Install the system at a distance from other electric appliances and TV.
÷ Set the TAPE EQ. to on. ™
÷ Clean the head referring to "Maintenance". Q
÷ Wind the tape again by fast forwarding, rewinding or playing from
an end to the other. ¡™
÷ Use a cassette with an unbroken recording protect tab or block
the hole. W
÷ Close the holder completely. ¡
÷ Set the input selector to the source to be recorded. ¶
÷ Change the tape transport direction or reverse the tape insertion
orientation. ¡
Remedy Symptom
Sound cannot be produced by pressing the play
key.
No operation occurs even when an operation
key is pressed.
The cassette holder cannot be opened by
pressing "
0 push open".
Sound is harsh or high frequencies are not re-
produced.
Sound is distorted.
Noise is noticeable.
Sound vibrates.
Recording cannot be started by pressing the
record key.
In case of difficulty