Key Digital KD-VA5 - Manual (Page 6)

KD-VA5 Operating Instructions
Page 
KD-VA5 Operating Instructions
Page 
KD-VA5 Operating Instructions
Page 
KD-VA5 Operating Instructions
Page 
Using only the 5 Volt, 1 Amp Power Supply provided with your unit, connect the power supply
jack to the KD-VA5 jack located near the RGBHV Output, and plug the power supply cord
into an appropriately rated power source.
› Configuration and Operation
Now that the KD-VA5 is wired into your system, the three slide switches on the side of the unit
near the Pb Y Pr Input must be set for the desired mode of sync operation. The LEDs on the
top of the unit verify the desired operation of the unit. For most applications, the Slide Switches
will be in the UP (default) position, and the Green LEDs will be ON.
A mounting clip (bracket) is provided to allow you to secure your KD-VA5 to a wall, rack,
etc. It is suggested that you fully operate the unit first (see the following “Configuration and
Operation” section of this Operating Manual) before securing the unit in its mounting bracket.
Then, use an appropriate fastener to secure the bracket to a safe, dry location, and carefully
snap the KD-VA5 into its mounting bracket. If you need to remove the unit from the mounting
bracket, use care to pry the unit out without snapping the clips.
›
Carefully insert the power
supply jack into the KD-VA5
5 Volt, 1 Amp Power Supply
connected to the KD-VA5
Secure the mounting clip to
a wall or other surface, and
carefully insert the KD-VA5
into the clips
KD-VA5
Mounting Clip,
provided
Yellow LEDs indicate when
the corresponding Slide Switch
is in the DOWN position
Green LEDs indicate when the
corresponding Slide Switch is
in the UP (default) position
Red LEDs indicate:
RGB-to-YPbPr or
YPbPr-to-RGB Conversion
Slide Switch 3 controls
these two functions
Slide Switch 2 controls
these two functions
Slide Switch 1 controls
these two functions
The 3 Slide Switches determine
the Sync Input / Output modes Slide Switch [ 1 ] [ 2 ] [ 3 ]
KD-VA5_Manual.indd 8-9 8/2/06 11:56:13 AM