Kenwood DPX701U - Manual (Page 38)

English | 37
Display Illumination Control
This function turns off the display when you
perform no operation for 5 seconds. This function
is effective when you are driving at night.
Display Setting
"Display : ON"/
"DISP ON" Keeps the display on.
"Display : OFF"/
"DISP OFF" Turns off the display when you perform no
operation for 5 seconds.
• Set the Display Illumination Control when the
<Demonstration mode Setting> (page 44) is set to
OFF.
• When the display is off, pressing any key will turn on
the display.
• When the display is off, you cannot perform any
operation except for the following:
• Volume
• Attenuator
• Selecting the source
• Ejecting the disc
• Turning off the power
• During function control, such as the Menu System, the
display stays on.
In Standby mode
Dimmer
Dimming this unit’s display automatically when
the vehicle light switch is turned ON.
Display Setting
"Dimmer : ON"/ "DIM ON" The display dims.
"Dimmer : OFF"/ "DIM OFF" The display doesn’t dim.
Function of the DPX501U
In Standby mode
Switching preout
Alternating the preout between the rear and
subwoofer. (With the subwoofer the sound
outputs without being effected by fader control.)
Display Setting
"SWPRE R" Rear preout.
"SWPRE SW" Subwoofer preout.
In Standby mode
Built-in Amp Setting
Controlling the built-in amplifier.
Turning OFF this control enhances the preout
quality.
Display Setting
"AMP : ON"/ "AMP ON" The built-in amplifier activates.
"AMP : OFF"/ "AMP OFF" The built-in amplifier deactivates.
Other than Standby mode/
When the Dual Zone System is ON
Dual Zone System Setting
Setting the Front channel and Rear channel
sound in the Dual Zone System.
Display Setting
"Zone2 : Rear"/
"ZONE2 R" Sub source (Auxiliary input source) is to be rear
channel.
"Zone2 : Front"/
"ZONE2 F" Sub source (Auxiliary input source) is to be front
channel.