Kicker IX500.2 - Manual (Page 3)

3
Model External Fuse
(sold separately)
Power/Ground Wire KICKER Wiring Kit
IX500.2 1 x 60 Ampere 4 Gauge PK4, CK4, ZCK4
Wiring: Disconnect the vehicle’s battery to avoid an electrical short. Then, connect the ground wire to the
amplifi er. Make the ground wire short, 24” (60cm) or less, and connect it to a paint-and-corrosion-free, solid,
metal area of the vehicle’s chassis. Adding an additional ground wire of this same gauge (or larger) between the
battery’s negative post and the vehicle chassis is recommended.
The IX amplifi er has dual input sensitivity differential RCA inputs which will receive either high or low level signals
from your car stereo’s source unit. A high-level signal can be run from the source unit’s speaker outputs to the
stereo RCA input on the end panel of the amplifi er using the KICKER ZISL as shown below (make sure you set
the IX amplifi er’s input level switch to “HI”). Alternatively, the signal can be delivered to the amplifi er using the low-
level RCA outputs on the source unit. Set the input level switch on the end panel of the amplifi er to “LO”. Either
input method will provide a low-level output signal at the RCA output, which effectively passes the audio signal
to another amplifi er or component. Keep the audio signal cable away from factory wiring harnesses and other
power wiring. If you need to cross this wiring, cross it at a 90 degree angle.
source unit
high-level speaker
outputs
to amplifi er
shield
+
–
core conductor
Install a fuse within 18” (45cm) of the battery and in-line with the power cable connected to your amplifi er. Install
a second fuse within 18” (45cm) of the amplifi er. If you ever need to remove the amplifi er from the vehicle after it
has been installed, the ground wire should be the last wire disconnected from the amplifi er--just the opposite as
when you installed it.
KICKER ZISL
source unit high-level
speaker outputs
OR
to amplifi er
INPUT
LEVEL
LO
HI
INPUT
L
R
OUTPUT
POWER SPEAKERS
GND L+ L– R+ R– REM +12V
AUTO
TURN ON
12V DC AUDIO
OFFSET
BRIDGED
12V
18”
(45cm)
battery
external fuse
remote turn-on
(see page 5)
bare-metal
chassis ground
24”
(60cm)
2010 IX 500.2 RevF.indd 3 2010 IX 500.2 RevF.indd 3 11/5/2010 12:32:10 PM 11/5/2010 12:32:10 PM