Klegg electronic M6 501P - Manual (Page 22)

21
M6 501P Operation – Time Delay Adjustment on Surround Speakers
Delay Calibration
DRC
balance delay prologic
field EQ on/off EQ setup
preset 1 preset 2 preset 3
save preset 4 load
Cen
SW
VOL
SL/SR
D Time
Press DELAY Button to select the length of delay
time for SL/SR/C channels. Repeatedly pressing
the DELAY Button will allow you to select the 3
surround speakers (SL, SR, C.)
The delay time range for SL/SR is 0 to 15 ms and
0 to 5 ms for Center.
Adjust the delay time on the selected channel by
pressing D TIME + or D TIME - on the remote
control.
Surround Speaker Delay
Delay calibration for the surround speakers is necessary when the surround speakers are
placed close to the listening position. Placing surround speakers too close to the listing
position without adjusting the delay time will significantly reduce the quality of your movie
soundtrack. To correct this problem, press the DELAY Button repeatedly until SL/SR appears on
the display. Increase the time delay of the surround speakers by pressing D TIME + until you
are able to hear a 3D sound effect coming from surround speakers.
Press the DELAY Button again and the M6 501P will cycle to next channel:
D o l b y D i g i t a I C o
D E L A Y S L 5 m s
D o l b y D i g i t a I C o
D E L A Y
S R 5 m s
Pressing D TIME + or D TIME - will increase or decrease the delay time for the selected
channel:
D o l b y D i g i t a I C o
D E L A Y S R 6 m s