Kodak Printe - Manual (Page 32)

Installing additional memory A-2
VinylJet 36 TM Reference Guide
➪
To remove the SIMMs
1 Facing the top of the SIMMs, push the side
clips gently to the outside (away from the
SIMM).
2 Push over and pull out, being careful not to
damage the fingers on the top.
➪
To install the new SIMM
1 Insert at a 45 degree angle and slowly push the SIMM to a 90 o angle until the
two side clips snap into place. Make sure the SIMM is fully seated.
2 Carefully reconnect the ribbon cable harness to the connector on the PC
board. Reattach the other connectors removed earlier.
3 Reinstall the right cover and top cover.