Karcher SC 1122 - Manual (Page 7)

English 7
Î Tightly insert the steam plug (C6) into
the appliance connector (A1). The plug
must click into place audibly.
Î Connect the required accessories to the
steam gun (C1). Insert the open end of
the accessory on the steam gun and
push onto the steam gun until the un-
locking button (C2) of the steam gun
locks into place.
Figure 1
Î Use the extension pieces (G1) if neces-
sary. To do so, connect one or both ex-
tension pieces to the steam gun (C1).
Insert the required accessories on the
free end of the extension piece.
Figure 2
ṇ
DANGER
Hot water may drip out of the accessory
parts while you are detaching them! Never
detach accessory parts while steam
streams out - risk of scalding!
Î
Push the lock (C3) to the front (steam
switch blocked).
Î To detach the accessory parts, press
the unlocking button (C2 or G2), and
pull the items apart.
Figure 3
Note: If you always use usual commercial
distilled water it is not necessary to descale
the boiler.
CAUTION
Do not use condensation water from the
drier! Do not fill in detergents or other addi-
tions!
Î
Remove the safety clamp (A3) from the
device.
Î Empty remaining water from boiler.
Î Fill the boiler with a maximum of 1.2 lit-
ers of fresh tap water.
Note: The boiler can be filled up to 2 cm
below the edge of the filler neck. You
can cut down the heating-up time by us-
ing warm water.
Î Screw the safety clamp (A3) back onto
the device.
Operation
Attaching the Accessories
Removing the Accessories
Fill up with water