Kenwood KTC-HR200 - Manual (Page 5)

English | En-5
Receive Mode
Sets the receive mode.
1 Select menu mode using the control unit.
Select the menu item.
Select the "Receive Mode"/ "HDR mode" display.
2 Open Receive mode
Press the setting button of the menu items in
the control unit for at least 1 second.
3 Set the Receive mode
Switching the setting of menu items.
Each time the button is pressed the Receive mode
switches as shown below.
Receive mode Display Operation
Auto mode "Auto" Automatically tunes to analog
broadcast when there is no digital
broadcast.
Digital "Digital" Digital broadcasts only.
Analog "Analog" Analog broadcasts only.
4 Exit Receive mode
Press the [MENU] button.
5 Exit Menu mode
Preset Memory
Putting the frequency and channel in the memory.
1 Select the band
Press the [FM] or [AM] button.
2 Select the frequency to put in the memory
Press the [ 4] or [¢] button.
3 Put the frequency and channel in the memory
Press the desired [1] — [6] button for at least 2
seconds.
The preset number display blinks 1 time.
On each band, 1 station can be put in the memory
on each [1] — [6] button.
Preset Tuning
Calling up the frequency and channel in the
memory.
1 Select the band
Press the [FM] or [AM] button.
2 Call up the frequency and channel
Press the desired [1] — [6] button.
⁄
• "Linking" will be displayed for few seconds until it is
received.
• If the Sub channel is not available, the main channel will
be received.
• When <Receive Mode> (page En-5) is set to Digital or
Analog, it cannot be received if the setting is differed
form the preset.