Konica Minolta DiMAGE Z1 - Manual (Page 86)

86 S
ETUP MENU
LCD monitor brightness
Monitor brightness can be adjusted in 11 levels.
Brightness can be set individually for viewfinder and
direct viewing in the recording mode. Turn the mode
switch to the appropriate position before opening the
brightness option in section 1 of the setup menu (p. 84).
Also see page 28.
Use the left/right keys of the controller to adjust bright-
ness, the monitor image changes accordingly. Press the
central button of the controller to set the level.
Auto power save
To conserve battery power, the camera will shut down if no operation is made within a certain period.
The length of the auto-power-save period can be changed to 1, 3, 5, or 10 minutes. When the cam-
era is connected to a computer, the auto-power-save period is fixed at ten minutes. Auto power save
is set in section 1 of the setup menu (p. 84).
Set LCD brightness
:select :enter
Low High
An image can be displayed on the monitor after it is captured. When
used with the continuous-advance drive mode (p. 46), thumbnails of
the last six images in the series will be displayed. Instant playback is
activated section 1 of the setup menu (p. 84). A playback period of
two or ten seconds can be selected. To cancel the playback and save
the image before the end of the playback period, press the shutter-
release button partway down.
Instant playback
Single still images can be previewed immediately after being captured without instant playback
active. Simply continue to hold the shutter-release button down after taking the picture to display
the image. Release the shutter button to end the playback.
Camera Notes