Koss KS4192 - Manual (Page 17)

E 16
Progressive Scan
By displaying all the lines of a picture simultaneous (instead of displaying odd
and even lines alternatively such as a conventional TV), Progressive Scan
greatly enhances picture resolution while minimizing distortion and flickering.
To use this feature, your TV must be Progressive Scan compatible
with Component Video input jacks connected to the DVD unit.
1.
Set your unit to NTSC output mode.
2. Select the Progressive Scan option and press OK (or V.Select on the
remote control) to activate.
3. A caution message will display. Press OK to continue.
Caution: If you see distorted or no picture after pressing OK, then check the
following:
i) Your TV may not be Progressive Scan compatible. Wait a few seconds
and the unit will return to the previous setting before it was changed.
ii) Make sure your TV is connected with Component Video output from the
DVD unit and is now switched to view such input through which
Progressive Scan signals are transmitted . There will be no video signal
from AV output, in case you have both Component Video and AV
connections.
4. A message requesting for confirmation will appear on screen. Select
Yes (confirm) or No (return to previous setting) by
and press OK to confirm.
SOUND
DRC
Press OK to turn on/off. This controls the Dynamic Range Compression
(DRC) for night time listening. DRC reduces the difference between normal
voices and sounds such as like explosion to avoid waking your neighbours.
The amount of range control available depends on the disc.
Digital Output
Press OK to check the box if you have connected the unit’s digital audio
output to a receiver with Dolby Digital or DTS.
Speaker Setup
Three options are available to adjust your speakers setting to
best fit your listening environment.
Speakers
You can indicate the presence and size of speakers you have
connected to your system within this menu. Options available are
as below. Press OK to confirm your selections.
Sound
Digital Output
Speaker Setup
PL II Mode
DRC
PL II Control
Music
Off
On
The setting will change to Progressive Scan ON.
Incorrect setting of this item can distort the picture or no video
can be observed after proceeding this step. To retrieve correct
video output, you can press V.SELECT key several times.
Do you want to continue?
No, switch to Component output.
Yes, switch to Progressive Scan output.
Does your TV support Progressive Scan mode? and
Have you connected the Component Video Output cable to your TV
and your TV has set up accordingly?
Yes
No
Center
Subwoofer
Surround
Front Speaker Size
Surround Back
Front