KRK ERGO - Manual (Page 15)

15
RoomPerfect™ can derive information about:
• Room acoustic properties and modes (peaks and dips in
the room)
• Power response throughout the room
• Loudspeaker directivity
• High frequency roll-off
• Characteristics of low frequency roll-off
From the acquired measurements, RoomPerfect™ processes the
information and sets up amplitude targets and limiters for the
different filters in an automated process. The most challenging
task for a room correction system is the automated correction of
an already near ideal system – but RoomPerfect™ is capable of
solving even this challenge and compensates using minor
corrections.
In the ERGO system, RoomPerfect™ automatically identifies the
optimal target curve from the information in the measurements
and everything after that is controlled by the calibration
software (ERGO Cal). In a new ERGO installation, the software
guides you through the set up sequence, indicates when to move
the microphone, monitors the quality of the measurements, and
continues the process until the necessary information is retrieved
and the filters for “global” and “focused” correction can be
calculated.
Visit www.lyngdorf.com/index.php?option=com_content&task
=view&id=91&Itemid=35 to find information about
RoomPerfect™.
33..66 SSooffttwwaarree IInnssttaallllaattiioonn
To install ERGO Cal software, insert the KRK ERGO Installation
CD and follow the next instructions;
M Maacc
1. Insert the KRK ERGO Installation CD and double click the
ERGO software installer.
2. After the installation process is finished, the ERGO
Calibration Wizard will start automatically. Follow its
instructions.
In Mac systems, ERGO uses Apple’s Core Audio FireWire
functionality to provide plug and play operation. Once
connected to a Mac’s FireWire port, ERGO is recognized and
automatically added as an option in the Sound Preference panel
and to any Core Audio compliant software.
PPCC
If the KRK ERGO Installation CD does not automatically Autorun,
double click My Computer, right-click the KRK ERGO icon, and
click O Oppeenn.
1. Double click the ERGO Software v1.0.0.exe. The KRK ERGO
Installation Wizard will guide you through the installation
process.
2. After the installation process is finished, the ERGO
Calibration Wizard will start automatically. Follow its
instructions.
To open the ERGO Control Panel go to Start > Programs > KRK
ERGO and click EERRG GO O CCoonnttrrooll PPaanneell..
Once installed correctly, you should have the following items on
your computer:
• PDF of the ERGO User’s Manual
• ERGO Cal Room Correction Software
• ERGO Control Panel
• ASIO and WDM Drivers (installs on PC only)
33.. SSeettttiinngg uupp EERRG GO O aanndd yyoouurr M Miixxiinngg EEnnvviirroonnm meenntt