King Canada 9818-RJ - Manual (Page 12)

Fig. 8
Page 10
IMPORTANT! The installer is responsible for weatherproofing all holes in the vessel.
Note: The installer is responsible for determining the most appropriate fastener to secure the
dome unit to the pedestal or vessel surface. Depending on the surface material,
fasteners such as lag screws, well nuts, sheet metal screws, toggle bolts and T anchors
may be used.
Use the included white foam gasket(s) to seal the coax connection area (see Fig. 8 for
mounting configurations).
1. Mount the dome unit. Use the four mounting holes inside the base to install the dome
unit to the pedestal or the vessel surface.
IMPORTANT! Make sure power supply is disconnected from 110 volt source before
continuing with permanent installation.
Note: The King-Dome is wired for a dual LNB. There are two coaxial ports on the bottom of
the dome unit. The one labeled “MAIN” must be connected to the Tuner (IDB) in vessel.
The unlabeled port can be used for an additional receiver (see page 13). If using both
coax, label the other end of one to avoid confusion when making the internal hookups.
Apply non-conductive electrolytic grease to all stingers (coax cable center conductors)
before installation.