Kingston Technology MCMASTER MC133PD - Manual (Page 19)

Appendix A Configuration Options 13
MCMaster User’s Guide - Rev. B06 Kingston Technology Company
If you use the MCMaster driver, place it after the driver for the memory board
in your CONFIG.SYS file. For example:
DEVICE = [Memory board driver].SYS
DEVICE = MMPIDD.SYS
Early versions of the Intel Above Board implement the INITPROG option in a
different manner. For these boards, Intel provides a program called SOFTSET.
If you are using the MCMaster with one of these Intel Above Boards, please
read "The MCMaster and the Intel Above Board" contained in Appendix C.
Later versions of the Above Board use an Installable Device Driver; for these
boards, the instructions here will suffice.
If you need to use the INITPROG option, make sure that you have a version of
the IBM Set Configuration program that supports this feature. Older versions
may not. The newer versions of the Set Configuration program prompt you to
use [F3] rather than [ESC] to exit the program. If you need the newer Set
Configuration program, contact your IBM service representative. Assuming
that you have the proper configuration program, you must first edit the
MCMaster's ADF file to enable the INITPROG feature of the Set
Configuration program. To do so:
1. Boot up the system if it is not already running.
2. Insert the Reference diskette into the floppy drive.
3. Ensure that the second required ADF file is also on your Reference
disk. To do this, use the DOS DIR command:
C:\>dir a:?008E.ADF
You should see something like:
I008E.ADF
@008E.ADF
2 files found
If you don't find I008E.ADF, copy it from the option diskette onto
the Reference diskette before proceeding any further.
4. Load the file A:@008E.ADF into your favorite text editor or EDLIN.
At or near lines 12 and 13, you will see: