Kenwood RC-R0507 - Manual (Page 5)

5
RC-R0507 (En/T)
Remote Control
The macro play function allows you to set the remote to control several
components in succession. After completing this setup, you can
perform a series of operations automatically. Enter the setup codes for
the components you want to control beforehand.
Preparing for automatic operations
(MACRO play)
Getting the most from your remote control
1
Make a plan of the macro play you want to Setup.
The order of the operations may be fairly complex and you may
not be remember all of the necessary commands during the
setup procedure.
Use the space provided below to write down the operations in
the order you are going to enter them.
1 !
2 @
3 #
4 $
5 %
6 ^
7 &
8 *
9 (
0 )
• Up to 20 steps can be memorized for each macro.
• The example below shows the plan for step
4 (which occupies a
total of 9 steps) :
1 TV + SHIFT + POWER 3 steps
2 FUNCTION SHIFT + 4 2 steps
3 VIDEO + VIDEO 2 steps
4 SHIFT + POWER 2 steps
Total 9 steps
• If you attempt to store more than 20 steps, the remote will output
one long blink and exit the macro programming mode.
• Enter channel numbers (for the monitor TV, etc.) exactly as you
would using the original remote.
2
Press and hold the MACRO key until the backlight flashes
twice.
Perform each of the following steps within 5 seconds.
• To operate a TV, start from step 2.
Go to step 2 within 3 seconds.
1
2
Press the SHIFT key.
Press the VIDEO, AUDIO or TV key repeatedly to display
the remote control mode for the component you want to
control.
Changing (confirming) the operation mode
3
Execute the desired operations.
• See "Remote operation of other components" for a list of keys
available with each component. RC $
The operation mode remains set at the component specified in
step
2 .
To return control to the original component, press SHIFT and
then press the VIDEO or AUDIO key to return to the original
control mode.
• Pressing any other keys after the SHIFT key cancels the shift
function and sends the normal code associated with the respective
key.
• The input selector does not change during this operation.
• If you press
VIDEO or AUDIO key more than 3 seconds after
pressing the SHIFT key, the input selector changes together with
the operation mode.
The component to be controlled is displayed in parenthesis
This operation lets you change the remote control operation mode
without changing the input selector.
You may find this useful when you want to control one component while
using another. (For example, if you want to rewind the tape deck while
listening to a CD.)
This operation is also useful if you don't know the which mode the
remote control is set to. Executing this operation allows you to change
or reconfirm the operation mode you desire.
SHIFT
VIDEO, AUDIO, TV
MACRO
VIDEO, AUDIO, TV
3
• You can store up to 3 different macros, one at each key:
VIDEO = "MACRO 1", AUDIO = "MACRO 2", TV = "MACRO 3"
• The backlight flashes once when you select the macro location.
• Pressing a key other than
VIDEO , AUDIO , or TV cancels the macro
program mode.
When VIDEO is pressed
Press the VIDEO, AUDIO, or TV key to select the macro
location. (MACRO1, 2, and 3 respectively)
CD A SP
SW
R L
MACRO1 A SP
SW
R L
Continued to next page