Kathrein HDZ 100 - Manual (Page 12)

12
CABLE CONTINUATION VARIANT
1. First cut the cylindrical spigot off the
underside of the casing. There are
two ways of doing this:
- use a sharp knife to cut through the
wall between the base of the casing
and the spigot (see illustration on the
right) or
11. Use the plugs supplied to seal the
cable attachment points that are now
not required (see illustration on the
right).
Do not cut away any plugs that are
not required, you will need them
if you ever wish to remove the
turntable system.
12. Now place the cover on the casing
lower half and screw the two halves
together using the four screws pre-
inserted in the cover (tightening
torque: M
A
= 1-1.5 Nm).
- use a hammer to knock out the spigot
Caution, risk of injury!
Caution, risk of injury!
INSTALLATION AND CONNECTION