Kodak Slide Projector - Manual (Page 30)

26 KODAK CAROUSEL® Slide Projector
Troubleshooting
Consult this guide before calling for service.
PROBLEM CAUSE CORRECTION
Projector does not operate No power to projector Plug power cord into suitable
electrical outlet. Set power
switch to Lamp.
No illumination on screen with slide in
projector gate Power switch on Off or Fan Set switch to Lamp.
Lamp burned out Install new lamp or lamp module
Lamp not seated in socket Check lamp.
Slide not in proper focus on screen
focus. Slide itself not sharp Examine slide for proper focus.
First slide in tray not properly focused Focus center of first slide
manually.
Slide in different type of mount from
others Focus manually.
Projection lens installed improperly Read and follow the instructions
for installing the lens.
Uneven edge-to-edge focus Slide itself is not sharp Examine slide.
Curved field lens used with glass,
plastic, or non-embosssed mounts Try a flat field lens.
(See “Choosing a Curved- or
Flat-Field Lens” on page 14.)
Curved field lens used for rear
projection Use a flat field lens.
Lamp performance UInstall new lamp and try again.
Autofocus motor runs continuously Multi-aperture slide or matte-suface
write-on slides in tray Turn off autofocus.
Autofocus fails to operate Lamp performance Install new lamp and try
autofocus again.