Kodak EasyShare C433 - Manual (Page 43)

Troubleshooting
www.kodak.com/go/support 37
Camera/computer communications
Camera freezes up
when a card is
inserted or
removed. ■ Turn the camera off, then back on. Make sure the camera is turned off
before inserting or removing a card.
Memory card full. ■ Insert a new card ( page 3 ), transfer pictures to the computer
( page 13 ), or delete pictures ( page 11 ).
Memory card and
internal memory
full. ■ Transfer pictures to the computer ( page 13 ), then format the card or
internal memory ( page 20 ).
Caution: Formatting a card deletes all pictures and videos,
including protected files.
If... Try one or more of the following
The computer does
not communicate
with the camera. ■ Visit www.kodak.com/go/c433support .
■ Turn on the camera ( page 2 ).
■ Install new batteries ( page 1 ) or charge rechargeable batteries.
■ See the Power Management section of the computer user’s guide to
disable this feature.
■ Connect cable to camera and computer port ( page 13 ).
■ Install the software ( page 12 ).
■ Disconnect the USB cable. Close all open applications. Re-install the
software (
page 12 ).
■ Disconnect camera from the computer. Close all software applications,
reconnect camera.
Cannot transfer
pictures.
(The Add New
Hardware Wizard
cannot locate
drivers.) ■ Disconnect USB cable. (If using camera dock or printer dock,
disconnect cable and remove camera from dock). Close all open
applications. Re-install the software (
page 12 ).
If... Try one or more the following