KTI Networks 24-PORT KGS-2401 - Manual (Page 28)

-28-
When you are at the top level, the prompt shows :>, and if you are at the group level, the prompt
displays the group name, e.g. System>.
To be under a certain group, you may enter the group name at top level or add / in front of the group
name then press enter at any level. Examples:
At top level: >system <enter> New prompt -> System>
At any level: system>/ip <enter> New prompt -> IP>
To be at top level, you may enter up at any level. (ex, system>up <enter>).
Note:
All the characters entered in the command line interface are NOT case-sensitive.
7.4 Help Utility
You can get command information by entering ? or help.
Prompt at top level
System System commands
Console Console commands
Port Port commands
MAC MAC table commands
VLAN VLAN commands
Aggregation Aggregation/Trunking commands
QoS QoS commands
Mirror Mirror commands
IP IP commands
Prompt at group level (Example: System>? <enter>)
System Configuration [all]
System Restore default [keepip]
System UserName [<name>]
System Password [<password>]
System systemname [<systemname>]
System Reboot
Help after a specific command (Example: System>configuration ?)
Syntax:
System Configuration [all]
Description:
Show System Name, Username, Password, Software Version, Hardware Version
and management MAC address. Optionally show the full configuration
[all]: Show the total switch configuration (default: System configuration
only)