Konica Minolta FAX2900/FAX3900 - Manual (Page 33)

5 Control Panel Operations (PC Print Mode)
5-6
Using the Bypass Tray
Use the procedure described below to print onto paper that is fed
automatically (up to 10 sheets at a time) from the bypass tray.
1 On your computer, display the printer driver, and then specify
“Bypass” as the
Paper Source setting (page 4-4).
2 Execute the print operation from your computer.
3 When the message “LOAD PAPER”
appears on the machine’s display,
load paper onto the bypass tray.
❍ This causes the print operation
to be performed using the paper
from the bypass tray.
4 Repeat step 3 as many times as necessary until printing of the
document is complete.
✎
Note
Be sure to execute the print operation from the computer first, and then
place the paper onto the bypass tray. If there is already paper on the
bypass tray when you execute the print operation, remove the paper,
and then place it again onto the bypass tray.
The bypass tray can be loaded with a maximum of 1 envelope, 5 OHP
transparencies, or 10 sheets of plain paper or cards.