Kambrook KS200 - Manual (Page 4)

4
before fIrSt USe
1. Before using your Kambrook Twin Speed Juicer
for the first time, remove any packaging material
and promotional stickers and labels.
2. Ensure that the motor base is switched to the
‘0’ position at the control panel. Ensure the
appliance is switched off at the power outlet and
the power cord is unplugged.
3. Press the safety lock button and pull the safety
locking handle downwards.
4. Remove the food pusher from the feed chute of
the juicer cover.
5. Lift and remove the juicer cover.
6. Lift the filter bowl surround with the stainless
steel filter basket still in place away from the
motor base. The stainless steel filter basket will
lift off with it.
WARNING: TAKE CARE WHEN
HANDLING THE STAINLESS STEEL FILTER
BASKET AS THE SMALL CUTTING BLADES AT
THE BASE OF THE FILTER BASKET ARE VERY
SHARP. MISHANDLING MAY CAUSE INJURY.
7. Lift the pulp container away from the motor
base.
8. Wash the filter bowl surround, filter basket,
juicer cover, food pusher, pulp container and
juice jug in warm, soapy water with a soft cloth.
Rinse and dry thoroughly. The motor base can be
wiped with a damp cloth. Dry thoroughly.
aSSembLING yoUr KambrooK
tWIN SPeeD JUICer
SteP 1
Place the motor base on a flat, dry surface such
as a bench top. Ensure that the motor base is
switched to the ‘0’ position at the control panel,
then switch the appliance off at the power outlet
and unplug the cord.
SteP 2
Place the pulp container into position by
aligning the slots on the pulp container with the
corresponding lugs on the motor base.
NOTE: To minimise cleaning, line the pulp
container with a plastic freezer bag to collect
the pulp.
SteP 3
Place the filter bowl surround on the motor base.
SteP 4
Push the stainless steel filter basket into the filter
bowl surround and push down firmly to connect
onto the motor drive coupling. Ensure it is fitted
securely inside the filter bowl surround and onto
the motor base.
SteP 5
Place the juicer cover over the filter bowl
surround. Slide the food pusher down the feed
chute by aligning the groove of the food pusher
with the small protrusion on the inside top of the
feed chute (facing the safety locking handle).
SteP 6
Raise the safety locking handle up and locate it
onto the latch on the juicer cover until it clicks
into place. The juicer will not operate unless the
safety locking handle is correctly locked into
position.