Connecting wires to terminals, English – Kenwood KDC-416S User Manual

Page 26

Advertising
background image

English

— 26 —

Connecting Wires to Terminals

+

+

+

+

+

FRONT • L

FRONT • R

REAR • L

REAR • R

P.CONT

ANT
CONT

FRONT

When only two speakers are being connected to the system, connect the
connectors either to both the front output terminals or to both the rear
output terminals (do not mix front and rear). For example, if you connect
the + connector of the left speaker to a front output terminal, do not
connect the - connector to a rear output terminal.

2CAUTION

If you connect the ignition wire (red) and the battery
wire (yellow) to the car chassis (ground), you may cause
a short circuit, that in turn may start a fire. Always
connect those wires to the power source running
through the fuse box.

2WARNING

FM/AM antenna input

Rear left output (White)

Rear right output (Red)

Fuse (10A)

KENWOOD disc changer control input
(KDC-416S/316S/37MR/316V only)

Wiring harness
(Accessory1)

White/Black

Gray/Black

Green/Black

Purple/Black

White

Gray

Green

Purple

To front left
speaker

To front right
speaker

To rear right
speaker

To rear left
speaker

Power control/
Motor antenna control wire
(Blue/White)

Ignition wire (Red)

Battery wire (Yellow)

Ground wire (Black)

· (To car chassis)

Ignition key
switch

Car fuse box
(Main fuse)

ACC

Car fuse box

Battery

If no connections are made, do not let the
wire come out from the tab.

Connect either to the power control

terminal when using the optional

power amplifier, or to the antenna

control terminal in the vehicle.

Front left output (White)
(KDC-416S/316S only)

Front right output (Red)
(KDC-416S/316S only)

To connect the Disc changer,
consult your Disc changer manual.

NOTE

KDC-416S(K)_U.S_ver2.0 00.12.26 0:58 PM Page 26

Advertising
This manual is related to the following products: