Kenwood KAC-X650D - Manual (Page 7)

English
7
MONO(Lch) STEREO
OPERATION A.CH B.CH FILTER
A.CH HPF
FILTER FREQUENCY(Hz)
LPF OFF HPF HPF OFF
B.M.S.
+12dB OFF REMOTE
INPUT SELECTOR
GND
EXT.AMP.CONT. LINE IN
L
R
L
R
A B SUB B A B A A SUB
200 50
B.CH HPF
200 50
B.CH LPF
200 50
SUB.CH LPF
200 50
30 30
SPEAKER
OUTPUT POWER IN
P.CON BATT. GND
FUSE(30Ax2)
LEFT
BRIDGED
RIGHT SUB
SUB
A
B
& @ # $ % ^
* ) (
@ Fuse (30 A
× 2)
# Battery terminal
$ Ground terminal
^ Amplifier A/B speaker output
terminals
• Stereo Connections:
When you wish to use the unit as a stereo
amplifier, stereo connections are used.
The speakers to be connected should
have an impedance of 2
Ω or greater.
When multiple speakers are to be
connected, ensure that the combined
impedance is 2
Ω or greater for each
channel.
• Bridged Connections:
When you wish to use the unit as a high-
output monaural amplifier, bridged
connections are used. (Make connections
to the LEFT channel
9 and the RIGHT
channel
· SPEAKER OUTPUT terminals.)
The speakers to be connected should
have an impedance of 4
Ω or greater.
When multiple speakers are to be
connected, ensure that the combined
impedance is 4
Ω or greater.
The rated input of the speakers should be no
less than the maximum output of the
amplifier. Otherwise malfunction may result.
& Amplifier SUB speaker output
terminal
As this unit accepts speakers with a
minimum impedance of 2 ohms, connect
speakers with 2-ohm or higher impedance
to these terminals.
* RCA cable ground lead terminal
When using an RCA cable with a ground
lead attached, connect the ground lead to
this terminal.
( A.CH/B.CH/SUB.CH LINE IN
terminal
% Power control terminal
Controls the unit ON/OFF.
Controls the unit power. Be sure to connect it
with all the systems.
) EXT.AMP.CONT. (external
amplifier control) terminal
Controls the B.M.S. Only Kenwood center
unit models sold in 1999 or later with a
"EXT.CONT."/"EXT.AMP.CONT." wire
attached can be used.
Also, a maximum of 3 power amplifiers can
be operated at the same time.
There are cases when operation may not be
possible due to wiring wire type and length.
NOTE
NOTE
2CAUTION
■ Terminal names
Connection