Kambrook CERAMIC KCE640 - Manual (Page 9)

9
Setting the Oscillation
The oscillation function works at both
operating temperatures.
Press the SWING button once to
activate. The heater will begin to
oscillate from side to side.
Press the SWING button again to stop
the heater from oscillating.
Setting the Auto-Off Timer
The timer function works at both
operating temperatures, and switches
the unit off after a preset number of
hours.
Press the TIMER button to activate the
timer settings. The 30 minute LED will
illuminate.
Press the TIMER
button to cycle
through the 30 minute and one hour
increments, up to 7.5 hours. The heater
will then switch itself to standby mode
after the selected number of hours
has passed.
ThermoGuard Overheating
Safety Device
Your heater is fitted with a safety
device that switches off the heater
in the event of overheating. Should
this heater stop working, turn off
the heater and inspect the air inlet
and outlet for blockages. Wait for at
least five minutes for the protection
system to reset before attempting
to restart the heater. If the heater
fails to operate or the safety device
switches off again, return the heater
to your nearest service centre for
examination or repair.
KCE640_IB_FA.indd 9 16/10/09 10:50 AM