Kompernass KH 1602 - Manual (Page 5)

- 3 -
• Avoid heat accumulation. Do not lay aluminium
foil or other grilling utensils on the grill bars. An
accumulation of heat could destroy plastic parts
as well as the non-stick coating.
• Use the Table grill KH 1602 exclusively with the
supplied thermostat.
• Take the grill plate into use ONLY when it is lying
on the catchment pan.
• Detach the power plug and cable from the
appliance when it is not in use, when you detach
parts or before cleaning the appliance.
Operating Elements
q Grill bars
w Splatter protection shield
e Connection for power cable with thermostat
r Catchment pan
t Heat-insulated handles
y Heating element
u Indicator lamp
i Thermostat
Taking it into use
Before taking the table grill into use for the first time
clean it as described in the chapter “Cleaning and
care”.
Usage / grilling may only take place with the catch-
ment pan
r intended for the purpose.
The voltage of the power source must tally with the
details given on the rating plate of the appliance.
Handling the grill
A good and even heat distribution is assured by the
integrated heating element
y in the grill plate.
Cleaning is made easier by the non-stick coating,
which prevents the adhesion of grillables.
• Fill the collecting pan r with a maximum of 0.5 l
of water. You can thus prevent the burning-on of
fats falling from the grillables and make the sub-
sequent cleaning of the appliance easier.
• Install the splatter protection shield w at the rear
of the grill bars should you be grilling greasy
grillables. Additionally, it serves well as a wind-
break if being used outdoors: Insert the three
tenons of the splatter protection shield
w into
the holes provided on one side of the grill bars
q . To do this, the splatter protection shield w
must be lightly flexed.
• Place the grill on an absolutely level and even
surface.
• Place the grill on a base material that is not
sensitive to heat.
• Check to ensure that the grill bars q are correctly
placed onto the catchment pan r (see Fig. Ạ).
• First insert the power cable with thermostat i
into the appliance and then connect it to the
power source.
• Adjust the thermostat i to the desired tempera-
ture setting.The grill starts to warm up and the
indicator lamp
u glows.
• As soon as the indicator lamp u goes out the
grill has reached the adjusted temperature and
is ready for use.
Take note
Subject to the ambient temperature, it can occur that
the control lamp
u does not extinguish on thermo-
stat setting "M".
• The grill is ready for use after a heating-up pha-
se of ca. 15 minutes.
IB_KH1602_E1944_LB4 07.02.2008 11:17 Uhr Seite 3