Konica Minolta Data Management Software CA-S20W - Manual (Page 20)

CONTENTS
18
Install
ing
C
a
li
bration Fil
e
s
1.4.4 File Path Settings
You can change the storage location of measurement files and calibration data and the file path of the
drive for the calibration disk.
1.
Select Tool - File Path from the menu.
The Option File Path dialog box appears.
2. Change each file path as necessary.
Click the Browse button to specify the existing file path.
In the ‘Save folder’ field, do not choose a location in the root directory of the hard drive (such as
C:\) but specify a folder.
For ‘Calibration data’, specify the folder one level higher than the folder with the serial number
(‘CA-S20w’ in the figure above).
3. Click the OK button.
If the file path setting is wrong, the Option File Path dialog box appears again. Check the file path
and specify it correctly.