Kenwood DVF-R5070 - Manual (Page 16)

DV-705/DVF-R5070 (EN/K,P,E,Y)
Set Up functions
16
Preparations
Set up menu
Set Up functions
Language Set up
OSD Language
Audio Language*
Subtitle Language*
Menu Language*
This switches the language for the on-screen display.
The SETUP functions are the following diverse functions. Please change them according to your use environment.
( ENGLISH )
Choose the language for the AUDIO output. ( ENGLISH )
Choose the language for SUB TITLE. ( ENGLISH )
Choose the language for the menu recorded on the DISC. ( ENGLISH )
Audio Set up
Digital Output
BitStream
LPCM
This selects the format of the audio output from the DIGITAL OUT terminal.
* When "Original" is selected for items marked with an asterisk (*), automatic switching to the language initially
set for the disc will be done.
Please refer to Page 26 for the languages compatible with this model.
Choose this for PCM output.
When a DVD recorded with Dolby digital is played back, output will be made converted to 2-channel
PCM.
And when a DVD recorded with DTS is played back, a bitstream signal will be put out.
LPCM Output
48kHz
96kHz
In case of 96 kHz digital signal, DVD will deliver 96 kHz signal out. In this case your receiver should
control 96 kHz signal.
This selects the clock frequency for linear PCM output.
Sets the linear PCM output to 48 kHz.
Even in case of 96 kHz digital signal, DVD will
deliver 48 kHz signal out.
The items in are the initial set values.
Choose this when connecting to an amplifier with built-in Dolby digital or DTS decoder.
When a DVD recorded with Dolby digital or DTS is played back, a bitstream signal will be put out.
When a disc recorded with linear PCM is played back, a linear PCM signal will be put out.
÷ After the power is switched ON, there is a
delay of about 3 seconds before the dis-
play is lit.
1 Set the POWER ON/OFF switch
to the ON ( ) position.
2 Set TV Format according to the connected TV type.
(Initial Settings
9)
1 NTSC
2 MULTI (NTSC/PAL switchable)
3 PAL
Preparation for Set Up
+
MAIN UNIT REMOTE
ANGLE
With no disc inserted, keep the ANGLE
key on the remote control pressed and
press the STOP key on the main unit. Each
time the STOP key is pressed, the setting
will be switched as follows.
How to use the RETURN key
When the RETURN key is
pressed, the display returns to
the previous screen (STOP
mode).
RETURN
POWER
- ON – OFF