Krown Manufacturing PVCO-C - Manual (Page 7)

II. Operation (CONT)
2. REQUESTING A VCO CALL
Move the PVCO down to the mouthpiece
of the handset. Press the “VOICE” button.
The machine is now sending a message to
the Relay operator to make a VCO call. At
the same time the machine will tell you to
wait with the message “SENDING PLS
WAIT.” After 2 seconds, the display will
tell you “MOVE TO EARPIECE NOW.”
Please move the PVCO to the earpiece of the handset and tighten the elastic
strap to the back of the unit around the handset. At this time, the Relay operator
will request you to use voice to communicate with him or her by message
(TALK NOW) or (VOICE NOW). The VCO call has now started.
3. VCO CONVERSATION
Speak the number you want to call
directly into the mouthpiece of the
handset. Say “GA” or “Go Ahead” after
finishing the sentence. The LED lights
up either when it is receiving from the
operator or when you are speaking to the
microphone. The progress of the call will
show on screen from the Relay operator.
Now you can really enjoy the convenience of this PVCO. Simply speak to the
phone and read the other person’s message back from the display.
4. END THE VCO CALL
To end the VCO conversation, you say “SK” or “Stop Keying”. Turn off the
PVCO by pressing the POWER button again and hang up the phone.
5. USING PVCO IN THE DARK
When you use the PVCO in the dark
you can turn on the blue-green
backlight to illuminate the screen. The
button has the light bulb icon and is
located on the left-hand side of the
PVCO.
6. TAKING PVCO WITH YOU WHEN YOU TRAVEL
Prior to a trip, verify that the machine is ready. Turn on the unit. You should
see the sign-on message. If not, install new batteries. Always carry extra
batteries in the pouch for easy replacement. Discard the old ones, do not put
them back into the pouch. It is a good idea to record every phone number into
the phone book which is included in the PVCO owner’s manual.
6